Remove the Oil Sending Connector on a 1998 Jeep Cherokee

Instructions

1
Locate the oil pressure sending unit on the right side of the engine block, behind the distributor. The unit will be bolted directly into the block, and will have a small wiring connector attached to it.

2

Uncle the wiring connector from the oil pressure unit. Pull the connector straight backwards to remove the wire from the sensor.

3

Turn the oil pressure sending unit counterclockwise, using the appropriate sized open-end wrench. Continue turning the unit counterclockwise until it is free from the vehicle.
Remove,the,Oil,Sending,Connector,on,a,1998,Jeep,Cherokee