Difference the Oil in a 2003 Crossing 6.0L

Instructions

1

Cultivate the slicker of the Ford using a 2-ton or greater volume run. Put diddlysquat stands beneath the figurehead phrase rails, retributive inside the lower manipulate blazon. Lour the truck onto the diddlysquat stands.

2

Move a 5-gallon or larger oil drain pan beneath the handcart. Take the oil feed stopper from the oil pan, using an open end distort. Tolerate the oil to run for no little than evener minutes into the feed pan. Put the avoidance secure when the oil is lengthwise out of the oil pan at a sluggish drip. It is substantive that you get as much of the old oil out of the engine as conceivable.

 3

Slide the drain pan to the rear of the oil pan. Use a large filter wrench to remove the old oil filter. You will need to use two hands to remove the old filter, as it will be heavy from the used oil. Check the old oil filter to make sure the gasket is still intact. If the gasket is not on the oil filter, remove the gasket from the oil filter mount on the engine. Set the old oil filter into the drain pan slowly, so as not to splash the used oil.

4

Insert a funnel into the new oil filter. Fill the new oil filter with 15W40 diesel motor oil. You may need an assistant to pour the oil in the filter while you hold the funnel and filter steady. Lubricate the O-ring gasket on the new filter with your finger and some of the new oil. Install the new oil filter and turn it clockwise, as tight as you can, by hand. Turn the filter 1/2-turn farther with the large filter wrench.

5

Remove the drain pan carefully from beneath the truck. Raise the front of the truck off the jack stands, then remove the jack stands from beneath the truck completely. Lower the truck to the ground.

6

Remove the oil fill cap from the engine compartment. Insert a large funnel into the oil fill hole. Pour the remaining oil from the three containers into the oil fill hole. The 2003 Ford 6.0-liter turbo-diesel engine requires 15 quarts of oil when changing the oil and filter. Install the oil fill cap back onto the engine.

7

Turn the ignition key in the truck to the accessories position. Wait until the orange coil plug light goes off. Start the truck engine and step out of the truck. Kneel next to the driver's door, and visually inspect under the truck for any leaks. If you hear a sudden hissing sound, or see oil puddling underneath the truck, shut the truck off immediately. Recheck the oil filter and oil drain plug to ensure they are both tight. Top off the motor oil, as needed.
Difference,the,Oil,in,a,2003,Crossing,6.0L